JANATICS 2/2 X 1/4" DIRECT ACTING

2/2 Direct-Acting VALVE 

Janatics E12612A 2/2 Direct Acting Solenoid Valve — A typical 2-way direct-acting solenoid valve, likely with 1/4″ port, suitable for pneumatic applications needing simple open/close control.
“2/2” means 2 ports, 2 positions — basically “on/off” control: inlet and outlet.
Typical port size is G1/4 (i.e. 1/4 inch), medium: filtered compressed air, and depends on model: orifice sizes like 2.5 NW, 2 NW etc. With inlet pressure ranges varying (for ex 0–7 bar, 0–10 bar, etc).

When choosing a 2/2 direct-acting valve (E-Series or similar), make sure to match:

• Port size (e.g. 1/4″ / G1/4) to your piping/fittings.
  Operating pressure (bar) range to your compressed-air system’s pressure.
  Orifice size & flow rate (lpm) to ensure adequate flow for your application.
  Coil voltage (AC or DC) and duty cycle/coil protection (IP rating) to your power supply and environment.
  Compatibility of the medium (air or other gas), and ensure proper air filtration.
  
  3/2 Direct-Acting VALVE 
  The “3/2” means this is a 3-port, 2-position directional control valve. That implies you have one inlet, one outlet, and one exhaust (or vent) port. These are commonly used for controlling a single-acting cylinder or to pressurize/vent a line in pneumatic systems
  
  

  Operating pressure :- Up to ~7 bar or ~10 bar depending variant — some E-series valves rated 0–10 bar.
  Flow rate (at 6 bar inlet, 5 bar outlet, Δp = 1 bar)  :- ~180, 140, or 60 L/min depending on orifice size / model.
  Coil / Voltage  :- DC/ AC coils available (50 Hz) e.g. 24 V, 48 V, 110 V, 220 V (± 10%) for different variants.

Send inquiry for JANATICS 2/2 X 1/4" DIRECT ACTING

Catalog

Looking For